M201 - won't print

Ariel
Posts: 5
Joined: Tue May 10, 2016 1:47 pm

Re: M201 - won't print

Post by Ariel » Wed Aug 24, 2016 6:16 pm

Today I print nicely, I just push a little the wire during the first layer and watch for buildup of drops on the bottom.
Otherwise it all works for me.

idom
Posts: 11
Joined: Sun May 29, 2016 12:00 pm

Re: M201 - won't print

Post by idom » Wed Aug 24, 2016 7:27 pm

Ariel wrote:You can cut a small piece of tube and stick it inside, as I did.
So you don't have to worry about insertion length.

I did so, but the tech support suggested direct insertion. Anyhow, it is not nice to be clueless during the building and this affects all new users.

Post Reply