Dual extruder sagging: anyone else

x306xcptnkirk · Post by **x306xcptnkirk** » Thu Jun 18, 2015 10:06 am

What is the best way to get abs to stick to the print bed? What settings should be used?

zhangxueyou · Post by **zhangxueyou** » Thu Jun 18, 2015 10:09 am

x306xcptnkirk wrote:What is the best way to get abs to stick to the print bed? What settings should be used?

You can smear a layer of glue to make the filament stick to bed. To print with an extruder, you can refer to this page to set slicer:
http://www.geeetech.com/forum/viewtopic ... 24&t=16366

x306xcptnkirk · Post by **x306xcptnkirk** » Thu Jun 18, 2015 10:15 am

Heat bed is at 95, extruder at 240 and elmers glue and it is still peeling up on the corners. What is the best glue to use?

zhangxueyou · Post by **zhangxueyou** » Thu Jun 18, 2015 10:25 am

x306xcptnkirk wrote:Heat bed is at 95, extruder at 240 and elmers glue and it is still peeling up on the corners. What is the best glue to use?

It'd better like this one: http://es.aliexpress.com/store/product/ ... 61306.html
You can also use common liquid glue but it's harder to get the item out of bed after printing.

Geeetech