Clogging every time i print

lucapon · Post by **lucapon** » Tue Jul 11, 2017 6:07 pm

Hi, I have a problem with my i3 pro b. Every time i try to print, filament clogs in the extruder troath. The extruder gets warm and the extruder motor works properly. Every time i clean the troath and the nozzle but when i insert filament and make it extrude it drops a little bit of pla and then nothing. what can I do? What is the problem?

dblajan · Post by **dblajan** » Wed Jul 12, 2017 4:25 am

Unfortunately, this is exactly what happens to me, too. Printer is an Aluminium Prusa i3 A.

Post by **William** » Thu Jul 13, 2017 10:12 am

Under this situation，we use to clear Interior of nozzle first，and then squeeze the screw which presses the filament，I guess your printer problem come from lacking of screw pressure.

lucapon · Post by **lucapon** » Thu Jul 13, 2017 4:27 pm

What screw are you talking about?

lucapon · Post by **lucapon** » Thu Jul 13, 2017 5:07 pm

If you are talking about the screw on top of extruder to adjust the tension spring, my printer has not it.

Post by **William** » Fri Jul 14, 2017 9:26 am

Info has been marked on the picture.

Geeetech

Clogging every time i print

Clogging every time i print

Re: Clogging every time i print

Re: Clogging every time i print

Re: Clogging every time i print

Re: Clogging every time i print

Re: Clogging every time i print