leveling the two extruders same hight

Post Reply
steven
Posts: 13
Joined: Sun Sep 13, 2015 10:39 pm

leveling the two extruders same hight

Post by steven » Sun Sep 20, 2015 10:39 pm

hello,

it's ok that i level one extruder one the printer bed but the second one is not the same hight as the first one.
i looked for solution and found one your site a picture that you have to losen some screws but the screw on the picture are the one who holds the motor carriage part tot the x-carriage part.
so that's not the solution is thing.

what can i doe?

thanks steven
Attachments
500px-Printer_setting5.png
500px-Printer_setting5.png (341.86 KiB) Viewed 4267 times

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: leveling the two extruders same hight

Post by Mark » Mon Sep 21, 2015 6:15 pm

The way you said works indeed, because of the elasticity of the PLA carriage. But it just fit for those nozzles that the gap are very small.
You can refer to the link here to find the right way:
https://www.youtube.com/watch?v=XGpcueIfUn8

Post Reply