Prusa Pro I3 C - Extruders still dont work

[TAMHAN]

Hello Folks,
after a long hiatus, I am back in action. I just installed the new firmware for my Prusa I3 Pro C, and the Extruders still cannot be turned.

My test sequence is:
a) Preheat ABS, wait until heat is reached
b) Move Axis -> Extruder -> turn pot, at which point nothing happens

Strangely, the printer operating software offers only one Extruder in the Move Axis option, while it offers two in the heatup menu and also welcomes me to a Prusa I3 C correctly.

[Mark]

Where did you get the firmware? The old verdion has a problem that can cause this, try to burn the attached firmware here.

[TAMHAN]

Hello,
I took it from the sticky thread. Weirdly, the extruders can be turned from Repetier...this seems to be an issue of the LCD only!

Tam

[Mark]

Do have some pictures about this?
"the extruders can be turned from Repetier" Can you control other parts of the printer by LCD, or just can not control the extruders?

[TAMHAN]

Hello,
yes - the axis can be controled from both LCD and Repetier.

The Extruder can be commanded only from Repetier.

[Mark]

Did you choose the option move 10mm? I remember this option does not work for extruder but only for X,Y and Z axis.

[TAMHAN]

Hello,
no, for me, neither of them worked.

Tam

[Mark]

Can you show some pics about the LCD for me?
"the axis can be controled from both LCD and Repetier.The Extruder can be commanded only from Repetier.'
When I choose move 10mm, there is no extruer for me too.see the pic below: