Error "Extruder switched off. MINTEMP triggered"

Post Reply
XYZM
Posts: 46
Joined: Tue Apr 28, 2015 12:36 am

Error "Extruder switched off. MINTEMP triggered"

Post by XYZM » Thu May 21, 2015 2:56 am

Using the GT2560 board, allows up to two extruders, but I only have one.

I measured voltage and resistance of the thermosister. I get Around 4.8V and around 80Ohms..

When I test for continunity I get no beeps from the thermosister. I think this is normal. The same goes for the heat bed thermosister.

In addition, when I attempt to heat the heatbed, nothing happens...
Top
Post Reply

Return to “Extruder”