Hot End taking forever to heat up

Post Reply
3dnewb
Posts: 6
Joined: Fri Mar 20, 2015 10:34 am

Hot End taking forever to heat up

Post by 3dnewb » Fri Mar 20, 2015 8:08 pm

Hey all I have my printer up and running but the hotend seems to be taking forever to heat up it starts at 24C and after 15 min is only at 27C I have checked all connections and they all seem good and you can tell the end is heating up by touch. and the Thermester is reading the temp does change on the display. any suggestions would be great
Thanks 3dnewb
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Hot End taking forever to heat up

Post by zhangxueyou » Mon Mar 23, 2015 11:33 am

When you are heating the extruder, is the temperature of hotbed raising? If so ,please connect the wire correctly, because you connect the exturder thermistor to hotbed pin.
QQ截图20150323112336.png
QQ截图20150323112336.png (248.03 KiB) Viewed 7520 times
Top
3dnewb
Posts: 6
Joined: Fri Mar 20, 2015 10:34 am

Re: Hot End taking forever to heat up

Post by 3dnewb » Mon Mar 23, 2015 6:02 pm

Thank you for your reply turns out i had the hotend plugged into the wrong spot I had it plugged in where the #2 hot end would go. Movd wires and works fine
Top
CDSeng
Posts: 1
Joined: Fri Mar 27, 2015 3:18 pm

Re: Hot End taking forever to heat up

Post by CDSeng » Fri Mar 27, 2015 3:49 pm

please send pics to verify, thanks!
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Hot End taking forever to heat up

Post by zhangxueyou » Fri Mar 27, 2015 3:56 pm

CDSeng wrote: » 27 Mar 2015 07:49

please send pics to verify, thanks!
Sorry, I don't get your point.
Top
Post Reply

Return to “Extruder”