Geeetech

Hi!
Im thinking to converting my printer from a 12v system to a 24v one.
Now im using 12v fan for the hotend and the part cooling fan, can i keep those or i need to replace with the 24v variant?
in the manual i found this:
As default, no matter the power supply is 12V or 24V; you need to connect the 12V fan as ther
e is a separate chip that can provide power supply for the fan. If you choose the 24V fan and 24V po
thanks in advance!

I think you should sync it because your system is 24v jigsaw puzzle

Hi

Hey as you can see here:

http://geeetech.com/forum/viewtopic.php?f=10&t=72678

I rebuild my old geeetech printer and using a 24volt powersupply.

But in this post you can see the problem i had with this:

http://geeetech.com/forum/viewtopic.php?f=18&t=72699

So I would recommend when using a 24 volt powersupply: Directly change all fans to 24volts ones!

Greetings Core2k