Geeetech

Got my printer put together and set up, and everything was working fine up to that point, lcd on, fans whirring, motors humming. When I was to try and get my first print started, I clicked preheat PLA, and everything turned off except for a green light on the PSU and on the GT2560 control board. I checked the power supply input to the control board, and it is supplying a full 12 volts, but when I check the voltage of the board, I get nothing. Could I possibly have a short somewhere and it busted the fuse when a power surge (Like clicking preheat) happened? Any help appreciated.

Hello, there may be a problem with your motherboard. You can provide pictures and videos in the ticket system on the geeetech official website, and someone will help you solve the problem.