Burn mark on GT 2560 Rev A+
Posted: Tue Aug 04, 2020 3:20 pm
Hi all,
My printer just stopped dead - none of the steppers will operate and this all happened at once for some reason. I had noticed a burn mark on the board a few weeks ago but the printer seemed fine so I am not sure the issue is connected. I have attached an image of the areas of the board affected but I have nothing connected to the pins next to the location of the burn so I have no idea what this is or why it happens - suggestions welcomed.
My printer just stopped dead - none of the steppers will operate and this all happened at once for some reason. I had noticed a burn mark on the board a few weeks ago but the printer seemed fine so I am not sure the issue is connected. I have attached an image of the areas of the board affected but I have nothing connected to the pins next to the location of the burn so I have no idea what this is or why it happens - suggestions welcomed.