A solid machine
Posted: Fri May 08, 2020 6:59 pm
Flashed marlin 2.0 from vertbreaker added a bl touch, a “better” cooling duct, and a purge “bucket” to use instead of prime towers and a piece of mirror to print on are the only modifications to the printer I have made. The prints that have come off this machine have been great for the profile I have used.
Pros:
its got a good build volume of 255x255x255
power supply and motherboard mounted underneath covered with a plate from front to back so no accidental touching of electronics.
dual bearings in each vslot wheel for stability
hotend breakout board makes connecting bltouch sensor easy
Pros:
its got a good build volume of 255x255x255
power supply and motherboard mounted underneath covered with a plate from front to back so no accidental touching of electronics.
dual bearings in each vslot wheel for stability
hotend breakout board makes connecting bltouch sensor easy