Geeetech

Posted: **Thu Jul 25, 2019 10:33 pm**

I'm thinking it wouldn't be the worst idea to take some stress off the board by putting an external mosfet board for the heatbed, the problem is that I couldn't figure out where to connect the triggering wire from the mosfet on the board.

Any help appreciated.

Posted: **Fri Jul 26, 2019 10:04 am**

Hi, you can refer to this: http://www.geeetech.com/wiki/index.php/ ... GT2560A%2B

Our schematic is open source and you can view it:https://github.com/Geeetech3D/Prusa_I3_ ... evA%2B.pdf

I hope this can help you.

Geeetech

2560 Rev B - how to add Heatbed Mosfet?

2560 Rev B - how to add Heatbed Mosfet?

Re: 2560 Rev B - how to add Heatbed Mosfet?