Hi, I've been trying to upload a bootloader onto my GT2560 Rev A because I've changed my z-axis to T8 leadscrews, I've bought a USBasp but either windows 10 doesn't pick it up or Arduino does recognize the com port I have also tried every type of driver on the zadig software. I run windows 10 with Arduino 1.0.6.
I believe I've wired it up properly using the wiring diagram on here but it still doesn't work please help!!!
(i am new to this if you can't tell
GT2560 Rev A Bootloader
Re: GT2560 Rev A Bootloader
Hello.
Show the screenshot from the Windows Device Manager.
You probably have a wrongly installed USBasp driver. In Zadig you have to choose USBasp , and driver "libusb-win32". Click "Reinstall Driver".
Show the screenshot from the Windows Device Manager.
You probably have a wrongly installed USBasp driver. In Zadig you have to choose USBasp , and driver "libusb-win32". Click "Reinstall Driver".
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: GT2560 Rev A Bootloader
Hello,
Sorry for the slow reply but I've already done what you've said and tried it again but it still doesn't work
I have also attached the screenshot you requested
Sorry for the slow reply but I've already done what you've said and tried it again but it still doesn't work
I have also attached the screenshot you requested
- Attachments
-
- Untitled-1.jpg (118.43 KiB) Viewed 5357 times
Re: GT2560 Rev A Bootloader
Hi.
In this case, the USBasp programmer must be selected in the program. This has nothing to do with the COM port.
You may need to set a slower transmission to the programmer.
New programmers are sold with old firmware.
In this case, the USBasp programmer must be selected in the program. This has nothing to do with the COM port.
You may need to set a slower transmission to the programmer.
New programmers are sold with old firmware.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.