Geeetech

Posted: **Tue Mar 19, 2019 10:44 am**

Hi,

I'm trying to connect a PT100 thermistor with amplifier. I managed to find a 5V and GND pins on the board, but don;t know where are the analog pins, or which numbers they would be.

Can anyone help?

Posted: **Tue Mar 19, 2019 11:43 pm**

Hello.

The diagram available for this controller board does not correspond to the physical realization.
The board has a dedicated connector.

: GT2560_v3_ADC.jpg (351.08 KiB) Viewed 4798 times

.
Here you have a description of the leads.

: pinout-ATMega2560_ADC.png (125.95 KiB) Viewed 4798 times

.
To check which pin corresponds to which µC lead, use a multimeter.
Unfortunately I don't have this controller board.

However, if you would like to present the results of your research here, it would be great.

Geeetech

Analog pins on GT2560 V3 (A20M printer)

Analog pins on GT2560 V3 (A20M printer)

Re: Analog pins on GT2560 V3 (A20M printer)