Page 1 of 1
Pinout for Extruder-cable needed
Posted: Sun Nov 18, 2018 7:24 am
by SebastianM
Hey,
can someone provide me the pinout for the extruder-cable on a gt2560 v3.0?
thx!!
Re: Pinout for Extruder-cable needed
Posted: Sun Nov 18, 2018 2:14 pm
by _kaktus_
Hello.
According to your wish.
- hotbed+hotend_conn-GT2560-v3.png (71.09 KiB) Viewed 10454 times
.
Re: Pinout for Extruder-cable needed
Posted: Fri Jan 04, 2019 3:20 am
by warbunnies
I'm trying to fix my friend's a10 because it came improperly wired (it fried the thermistor sensor on the board).
to make sure I have this right.
T0 = thermistor 0
HE0- = heating element 0, negative
The layout seems odd because it does not match the expansion card pinout for the extruder.
on the expansion card 11 & 12 are the heater & 7/9 is the thermistor... why do the opposite ends of the extruder cable have different pinouts?
Re: Pinout for Extruder-cable needed
Posted: Fri Jan 11, 2019 3:35 am
by _kaktus_
Hi.
warbunnies wrote: ↑Fri Jan 04, 2019 3:20 am
...
to make sure I have this right.
T0 = thermistor 0
HE0- = heating element 0, negative
...
We think the same in this regard.
warbunnies wrote: ↑Fri Jan 04, 2019 3:20 am
...
The layout seems odd because it does not match the expansion card pinout for the extruder.
on the expansion card 11 & 12 are the heater & 7/9 is the thermistor... why do the opposite ends of the extruder cable have different pinouts?
I am not able to answer these doubts.
