Pinout for Extruder-cable needed

[SebastianM]

Hey,
can someone provide me the pinout for the extruder-cable on a gt2560 v3.0?

thx!!

[_kaktus_]

Hello.


According to your wish.

hotbed+hotend_conn-GT2560-v3.png (71.09 KiB) Viewed 10461 times

.

[warbunnies]

I'm trying to fix my friend's a10 because it came improperly wired (it fried the thermistor sensor on the board).

to make sure I have this right.

T0 = thermistor 0

HE0- = heating element 0, negative


The layout seems odd because it does not match the expansion card pinout for the extruder.

on the expansion card 11 & 12 are the heater & 7/9 is the thermistor... why do the opposite ends of the extruder cable have different pinouts?

[_kaktus_]

Hi.

...
to make sure I have this right.

T0 = thermistor 0
HE0- = heating element 0, negative
...

We think the same in this regard.

...
The layout seems odd because it does not match the expansion card pinout for the extruder.
on the expansion card 11 & 12 are the heater & 7/9 is the thermistor... why do the opposite ends of the extruder cable have different pinouts?

I am not able to answer these doubts.