Page 1 of 1
GT2560 5v pins and GND
Posted: Wed May 31, 2017 2:21 am
by PauloSilva
Hello, can anyone help with finding 5v pins and GND
I would like to connect a relay of 5v to the GT2560
Can i use one vacant endstop? are they 5v?
Thank you
Re: GT2560 5v pins and GND
Posted: Thu Jun 01, 2017 2:03 pm
by William
Hi,here is the position of 5V and GND.
- 1.png (1.05 MiB) Viewed 8382 times
Re: GT2560 5v pins and GND
Posted: Thu Jun 01, 2017 7:03 pm
by PauloSilva
Is that a 5V PIN? what is the number of the PIN?
thank you
Re: GT2560 5v pins and GND
Posted: Fri Jun 02, 2017 11:20 am
by William
You can use the rest endstop pin of the board.There are actually 3 pins on the postition of endstop connector .Remove one of the connector from the board and replace it with a 3pin straight Pin.You need to use soldering iron here.Then you can use the +5V pin.
- 2.png (693.92 KiB) Viewed 8371 times
- 1.png (658.66 KiB) Viewed 8371 times