Page 1 of 1
GT2560 Rev A+ / 3D-Touch Problem
Posted: Tue May 09, 2017 10:02 am
by robkruss
I had to replace my original GT2560 Rev A board and received an Rev A+ board. I'm trying to connect the 3D-Touch to the new Servo pins (next to the temperature sensor pins) and cannot get it to work. The 3D-Touch on does 2 of the 3 extensions and can't be controlled by the M280 commands. I had this working before so I know how this should be acting. I purchased another Touch sensor and am having the same problem with the new sensor.
This is making me crazy! Please help.
..Rob
Re: GT2560 Rev A+ / 3D-Touch Problem
Posted: Fri May 12, 2017 11:23 am
by William
Hi,you need to adjust your sensor to normal status according to this video:
https://www.youtube.com/watch?v=Ix7lXvf ... e=youtu.be.Please let me know your lastest situation.
Re: GT2560 Rev A+ / 3D-Touch Problem
Posted: Sat May 13, 2017 9:22 pm
by robkruss
Hi William.
The issue has been resolved but the solution is not correct. As it turns out there is not a problem with the self test. What is the the issue is that the A+ board maps the SERVO0_PIN to 11 instead of 32. Since the A+ board leaves the ZMAX_PIN available there is no need to use its connection. It would be great if Geeetech would update the Marlin setting on the 3D-Touch with this new information.