Page 1 of 1
Board stop allowing firmware upload.
Posted: Fri Mar 31, 2017 1:06 am
by PrntNg
Have been able to upload software to GT2560A board previously, now the LAN input LED starts flashing very fast as soon as it is switched on. As it would if the software was being uploaded to it.
Re: Board stop allowing firmware upload.
Posted: Fri Mar 31, 2017 4:35 pm
by PrntNg
No software can be uploaded to it now states uploaded but not screen just light on lcd. Most likely due to the fact that after uploading with default setting of maximum steps mm/s being changed. As that is the only difference of the software that has caused it. Anyone know how to factory default reset it and burn boot loader from scratch. As even the reset by way way of the lcd and board is not working.