Geeetech

Hi!

I just received MeCreator 2 which has Rev. B of GT2560 board and I have few questions regarding that board:

It originally comes with A4988 stepper drivers which I would like to change for DRV8825
All 3 jumpers that determine steps are currently in place what would mean that A4988 drivers are set in 1/16 steps

Do I leave all 3 jumpers in place to get 1/32 steps from DRV8825?

Manual for Rev. A of GT2560 board states this for installation of DRV8825:

ON OFF ON 1/32 step
OFF ON ON 1/32 step
ON ON ON 1/32 step

Does the same apply for Rev. B?

What is the difference between those 3 jumper settings?
All 3 produce 1/32 step so what is the difference?

Does anyone have any schematics of Rev. B board?
Where are MOSFETs on this board?

I have also ordered 3dTouch auto level sensor.
Where do I connect it on Rev. B board?
Which are Z max and Z min connectors?

I'm aware that this a whole bunch of questions but I'm a total noob at 3D printing and there are no manuals for this board.

Any help would be greatly appreciated!

Thank you!

Regards,
Walter

Hi,Walter
I haven't heard someone mount a ABL sensor on Mecreator2 successfully...Do you think it is available?

It should be possible if there is a detail schematics of the board
As all other boards, this one also has end stop switches so theoretically it should work fine

Hi, have you find any solution for 3DTouch auto level sensor? where connect it?
Tnk if you replay