Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Heater bed burnt out now gt2560 is stuck in endless bootloop

http://geeetech.net/forum/viewtopic.php?f=18&t=18792

Page 1 of 1

Heater bed burnt out now gt2560 is stuck in endless bootloop

Posted: Tue Jan 17, 2017 4:42 pm
by mihokopi
The print bed, started smoking then burnt out refusing to light up, which caused the printer to reboot, which got it stuck in a loop where it reboots with everything powering up for 3-5 seconds then it resets and starts over.

Tried to boot it without the print bed connected but it continues to reboot every 3-5 seconds, cant flash it since it also disconnects/reconnects every reboot.

Any help welcome.

Re: Heater bed burnt out now gt2560 is stuck in endless boot

Posted: Tue Jan 17, 2017 5:35 pm
by bang
If so,the board can't connect to comouter any more...
How does the flashing proceed...? :roll:

Re: Heater bed burnt out now gt2560 is stuck in endless boot

Posted: Tue Jan 17, 2017 6:35 pm
by mihokopi
there is 3 1 second bursts of orange on the led between reboots on the control board.
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/