Heater bed burnt out now gt2560 is stuck in endless bootloop

[mihokopi]

The print bed, started smoking then burnt out refusing to light up, which caused the printer to reboot, which got it stuck in a loop where it reboots with everything powering up for 3-5 seconds then it resets and starts over.

Tried to boot it without the print bed connected but it continues to reboot every 3-5 seconds, cant flash it since it also disconnects/reconnects every reboot.

Any help welcome.

[bang]

If so,the board can't connect to comouter any more...
How does the flashing proceed...?

[mihokopi]

there is 3 1 second bursts of orange on the led between reboots on the control board.