Geeetech

Hi all,
Just finished putting Rostock 301 together. I like to exercise X/Y/Z motion up in the air without running heat bed or extruder motors. Does anyone have any motion exercise program can share? I like to be able to run circle diamond square, might be closed to each axis travel limits. Thanks.

Why not draw a circle to print to test the travel limit?

Thanks William.
Do you have a list of G-code and M-code descriptions for Rostock 301?
Thanks again for your support.

wushu2266 wrote:Thanks William.
Do you have a list of G-code and M-code descriptions for Rostock 301?
Thanks again for your support.

Hi,
I have no that.But some of the codes in the following article may work on 301:
http://reprap.org/wiki/Gcode#M106:_Fan_On

Hello,
Bonjour,

You will find the original text translated into English following this original French text.

Vous trouverez le texte original traduit en anglais à la suite du présent texte original en français.

Est-ce qu'il n'y a pas un mode de simulation d'impression dans Repetier-Host pour cela ?

Il n’y a que la tête d'impression qui bouge, pas de chaleur et pas d'extrudeur qui bouge !Il me semble avoir lu cela il y a quelque temps.

J'aimerais bien tester ce genre d'option, mais je ne sais pas où activer cette option.

Merci pour votre aide !

Cordialement,

L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,

Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!

Is there a print simulation mode in Repetier-Host for this?

There is only the print head moving, no heat and no extruder moving! It seems to me that I read this some time ago.

I would like to test this kind of option, but I do not know where to activate this option.

Thank you for your help !

Cordially,

Friend René