Geeetech

Hi,

i have a problem since 2 days on my prusa i3 pro C
I'm still calibrating it... but now i have a big poroblem

every time i begin to heat the bed, the printer crash. It seams to have an electrical problem, cause the fan stop to make noise, but still run
no possible to continu USB communication when this occure
I have to reboot the printer

I have check all connections, it seams normal, except that on the board, the green block containing the 2 wires for heating bed is moving a little bit. Except that everything OK

Really don't understand what lead to that electrical problem.
It seams also to be not all the time, but most

thanks

lezabour wrote:Hi,

i have a problem since 2 days on my prusa i3 pro C
I'm still calibrating it... but now i have a big poroblem

every time i begin to heat the bed, the printer crash. It seams to have an electrical problem, cause the fan stop to make noise, but still run
no possible to continu USB communication when this occure
I have to reboot the printer

I have check all connections, it seams normal, except that on the board, the green block containing the 2 wires for heating bed is moving a little bit. Except that everything OK

Really don't understand what lead to that electrical problem.
It seams also to be not all the time, but most

thanks

Haven't heard that...Can you show me how this happened?Besides,what you actually mean by saying "moving a little bit"?

Hi,

Ok,
How can i send you a video? cause you can't see youtube, and i can't upload a video in this forum...

let me know so i send you a video

lezabour wrote:Hi,

Ok,
How can i send you a video? cause you can't see youtube, and i can't upload a video in this forum...

let me know so i send you a video

Hi,
You can post a video link of Youtube,i guess i can watch it

lol ok
I think i solve the problem, i rewired and recheck evrything, now it seams OK;
Seams that it was a contact problem...
if problem come back, i will send you a video

thanks for help