Geeetech

Hi All
thought this would be the best place to start. On my current printers that we use the RAMPS 1.4 and ATMega2560 we have auto leveling setup with an induction sensor which is pretty simple as we use a metal plate and marlin firmware has it all in there.

I am wondering how would i go about setting up Auto leveling with an induction sensor replacing the Zstop on the M201 with the GTM32 control board. Is this possible?

Thanks for any advice and / or help

Kindly

Just curious if anything has come about with this issue?

i'm afraid not.As far as i know,the M201's board GTM32 is not open source...

Unfortunately noone has replied nor given me any extra information.

Im looking at removing the GTM32 Board as it not that great for the flexibility i need

replace it easily with a RAMPS 1.4 running marlin

which wills support the bedsize, auto bed tramming with induction sensor and multi nozzle extrsuion which is what we run on all our other printers now