Geeetech I3 Pro B all axes one direction
Posted: Thu Jun 16, 2016 1:33 am
Hey Ppl.
I have buid an I3 Pro B with the Board GT2560.
I can move all axes (XYZ) into only one direction,
even if i use LCD Panel or the Repetier Software.
is shown when i try to move an axil, but it isnt moving, only into other direction,
i Upgrade the Firmware and also uses an example firmware:
"Marlin_GT2560-PI3_Pro_B" from this forums.
i also umpluged the End Stop Sesores, no success, same error,
LCD Panel shows sometimes Endtop at X Axis.,, but... it isnt connected....
can anyone help me???
I can Provide Sceenshots or Pictures if needed.
Kind regards, Tim.
I have buid an I3 Pro B with the Board GT2560.
I can move all axes (XYZ) into only one direction,
even if i use LCD Panel or the Repetier Software.
19:22:35.213 : ok T:22.7 /0.0 B:22.4 /0.0 T0:22.7 /0.0 @:0 B@:0
19:22:38.275 : ok T:22.8 /0.0 B:22.4 /0.0 T0:22.8 /0.0 @:0 B@:0
19:22:41.338 : ok T:22.6 /0.0 B:22.5 /0.0 T0:22.6 /0.0 @:0 B@:0
19:22:44.401 : ok T:22.7 /0.0 B:22.5 /0.0 T0:22.7 /0.0 @:0 B@:0
19:22:47.463 : ok T:22.7 /0.0 B:22.5 /0.0 T0:22.7 /0.0 @:0 B@:0
19:22:50.526 : ok T:22.8 /0.0 B:22.4 /0.0 T0:22.8 /0.0 @:0 B@:0
is shown when i try to move an axil, but it isnt moving, only into other direction,
i Upgrade the Firmware and also uses an example firmware:
"Marlin_GT2560-PI3_Pro_B" from this forums.
i also umpluged the End Stop Sesores, no success, same error,
LCD Panel shows sometimes Endtop at X Axis.,, but... it isnt connected....
can anyone help me???
I can Provide Sceenshots or Pictures if needed.
Kind regards, Tim.