Geeetech

Posted: **Wed Jun 15, 2016 5:51 pm**

after inverting stepper direction Z lost all control of printer via LCD board and repetier, help please

Posted: **Wed Jun 15, 2016 6:00 pm**

chrisprint wrote:after inverting stepper direction Z lost all control of printer via LCD board and repetier, help please

Ensure the accuracy of your connection to the motherboard and the connection of Z motor's driver module.

Posted: **Wed Jun 15, 2016 6:55 pm**

i also get (Err;MINTEMP) also the display no longer displays the tempreture of the bed and hot ends

Posted: **Wed Jun 15, 2016 7:25 pm**

i have two machines, it did it on both

Posted: **Thu Jun 16, 2016 3:39 pm**

chrisprint wrote:i also get (Err;MINTEMP) also the display no longer displays the tempreture of the bed and hot ends

Posted: **Fri Jun 17, 2016 12:16 am**

i have used diffrent gt2560 boards with the same result!!!!

Posted: **Sat Jun 18, 2016 2:09 am**

the board shows err max temp but the display does not indicate temp just 00

Posted: **Sat Jun 18, 2016 9:02 am**

chrisprint wrote:the board shows err max temp but the display does not indicate temp just 00

Hi,
Have you already checked the link i posted?And could you take a pic of your LCD ?

Posted: **Sun Jun 19, 2016 12:34 am**

still no result

Posted: **Mon Jun 20, 2016 10:35 am**

chrisprint wrote:still no result

Hi,my friend
I think you'd better try to check it again as the links shows,maybe you've missed something.
Good Luck!

control board problem