Change to Arduino + Ramps
Posted: Sat May 28, 2016 2:57 pm
Hello that such. I have a Prusa M201 who buys it recently. After the armed one and of the connections, following the instructions of geeetech, I do not feel comfortable with the plate that comes the machine.
Would like to happen to use a Ramps 1.4 + ArduinoMega 2560, for question of comfort since I have other printers with these plates. And also I have to go to this because I her had several mistakes with the plate of geeetech, many of that lei in the forum that they spent to users, but the truth that I do not want to be all the time correcting.
Then, it wanted to know that configuration I must give him in the Marlin to load him in the arduino in order that it me works correctly.
From already thank you very much.
Would like to happen to use a Ramps 1.4 + ArduinoMega 2560, for question of comfort since I have other printers with these plates. And also I have to go to this because I her had several mistakes with the plate of geeetech, many of that lei in the forum that they spent to users, but the truth that I do not want to be all the time correcting.
Then, it wanted to know that configuration I must give him in the Marlin to load him in the arduino in order that it me works correctly.
From already thank you very much.