Page 1 of 1
Missing Heat Wire Connectors
Posted: Sun May 08, 2016 10:19 am
by socalborn
Almost completed the assembly and ran into a problem. There seems to be connectors that connects to the heating wires for the extruder and the bed and then you connect them to the control board. I've looked everywhere and I cannot find them. can I solder them directly or what?
Re: Missing Heat Wire Connectors
Posted: Mon May 09, 2016 3:18 pm
by Admin
yes, there should be 3 green connectors which can be removed, are they missing?
can you post a clear picture of the green part of the board?
Re: Missing Heat Wire Connectors
Posted: Wed May 11, 2016 1:20 am
by socalborn
I did post a clear picture of the green portion.
Re: Missing Heat Wire Connectors
Posted: Wed May 11, 2016 10:52 am
by Admin
socalborn wrote:I did post a clear picture of the green portion.
please contact the sellers to send you the replacement.