Mightyboard rev G overheating

Post Reply
glendonwaldner
Posts: 2
Joined: Wed Jan 13, 2016 5:26 am

Mightyboard rev G overheating

Post by glendonwaldner » Wed Jan 13, 2016 5:44 am

Hi I recently purchased a Mightyboard rev g from geeetech. I plan on installing it in my Makerbot 2.. I'm using the same Mean Well power supply. 24v 9.4Amps but when I connect the power to the board the processor IC gets really hot. It heats up and cools off while being powered on. The LCD board works good, it connects with my computer and it heats my extruder perfectly. I'm just concerned that the IC will overheat and burn up.... What could be causing this?
Top
Post Reply

Return to “Control Board”