I need the configuration for the prusa i3 acrylic dual extru
Posted: Sat Dec 19, 2015 6:28 am
Hello, i need help with the configuration of my prusa i3.
I need to load the software on the control board.
Can someone help me to do this ?
It would be nice an step to step tutorial.
My control board is one GT2560
i will apreciate all the help.
Thanks
I need to load the software on the control board.
Can someone help me to do this ?
It would be nice an step to step tutorial.
My control board is one GT2560
i will apreciate all the help.
Thanks