Page 1 of 1
Auto Leveling with a inductive sensor
Posted: Sun Oct 18, 2015 7:39 am
by Jeepfrog
Has anyone added an inductive sensor to there Delta Rostock mini G2s i have made the new platform and installed the sensor just not sure how to attach to the control board the only info i can find shows the RAMPS 1.4 board just not sure how to wire to the GT2560
Re: Auto Leveling with a inductive sensor
Posted: Mon Oct 19, 2015 4:57 pm
by Mark
Re: Auto Leveling with a inductive sensor
Posted: Thu Oct 22, 2015 6:17 pm
by Jeepfrog
here is what i found seams to be working
- 4.jpg (77.25 KiB) Viewed 14107 times
- 4.jpg (77.25 KiB) Viewed 14107 times
Re: Auto Leveling with a inductive sensor
Posted: Sun Nov 29, 2015 7:14 pm
by wayne
where specifically i will connect the 12 v supply? is it on the GT2560 board or on the power supply?
Re: Auto Leveling with a inductive sensor
Posted: Sat Oct 06, 2018 5:17 am
by RepMike
Thank you for this diagram! Does this also apply to the Current Board of the A10? I think this is the "Rev.B" board.