Geeetech

Hi,
Having finally worked out that, when the LCD was plugged in I could not Upload the firmware, Having managed to upload, when I turn the power on all 3 motors do one microstep up, then down, then up, etc until I turn the power off. Repetier Host will not control the motors & I get the following read-out:

18:03:50.579 : echo: Free Memory: 3615 PlannerBufferBytes: 1232
18:03:50.579 : echo:Hardcoded Default Settings Loaded
18:03:50.579 : echo:Steps per unit:
18:03:50.579 : echo: M92 X80.00 Y80.00 Z80.00 E93.00
18:03:50.579 : echo:Maximum feedrates (mm/s):
18:03:50.579 : echo: M203 X400.00 Y400.00 Z400.00 E45.00
18:03:50.579 : echo:Maximum Acceleration (mm/s2):
18:03:50.579 : echo: M201 X5000 Y5000 Z5000 E5000
18:03:50.579 : echo:Acceleration: S=acceleration, T=retract acceleration
18:03:50.579 : echo: M204 S1000.00 T2000.00
18:03:50.579 : echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
18:03:50.579 : echo: M205 S0.00 T0.00 B20000 X20.00 Z20.00 E5.00
18:03:50.579 : echo:Home offset (mm):
18:03:50.579 : echo: M206 X0.00 Y0.00 Z0.00
18:03:50.579 : echo:Endstop adjustement (mm):
18:03:50.579 : echo: M666 X0.00 Y0.00 Z0.00
18:03:50.579 : echo:PID settings:
18:03:50.579 : echo: M301 P22.20 I1.08 D114.00
18:03:51.954 : Error:Line Number is not Last Line Number+1, Last Line: 0
18:03:51.954 : Resend: 1
18:03:51.970 : Resend: N1 G1 X-1 F300 *56
18:03:51.970 : Resend: N2 G90 *50
18:03:51.970 : Resend: N3 G91 *50
18:03:52.907 : o?start
18:03:52.907 : echo: External Reset
18:03:52.907 : Marlin1.0.0

Can anyone tell what the problem Is?
Thanks, Walter