Geeetech

G'day.

I finally got my GT2560 going about two weeks ago, it's been working fine up until yesterday when the Extruded stopped feeding and does not respond to anything at all. I've set the min temp for extruding down to 10 for testing and still nothing. So now I have swapped over to my spare Sanguinololu and here the extruded stepper works fine. I hope the board has not died as I'm going to flip! I have also tried new stepper drivers and still no good.

Any ideas?

thanks

S

[quote="gemors"]G'day.

I finally got my GT2560 going about two weeks ago, it's been working fine up until yesterday when the Extruded stopped feeding and does not respond to anything at all. I've set the min temp for extruding down to 10 for testing and still nothing. So now I have swapped over to my spare Sanguinololu and here the extruded stepper works fine. I hope the board has not died as I'm going to flip! I have also tried new stepper drivers and still no good.

Any ideas?

hi,please

hi,did any trace of burned on the main board?

Hi mate,

No nothing wrong that I can see. Boars seems fine, now funny spells and mossfets are still fine too. i've tested the two fuses and they are still ok as well.

any thing else I can try

no, not that I can see

gemors wrote:no, not that I can see

did you try to reburn the firmware,some people have encountered with the same issue as yours.so,please tell me your printer type.i will send you the firmware.

hi mate

jesse wang sent me the firmware for the PI3B-GT2560,

while your at it can you also send me the marlin for Sanguinololu you sent me.

email is info@nata.net.au

thanks

J

gemors wrote:hi mate

jesse wang sent me the firmware for the PI3B-GT2560,

while your at it can you also send me the marlin for Sanguinololu you sent me.

email is info@nata.net.au

thanks

J

hi,friend .i've send it to your mailbox.