printerboard set up

Post Reply
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: printerboard set up

Post by zhangxueyou » Tue Apr 14, 2015 11:34 am

Not "sanguine", it's "sanguino".
Top
kryptonian
Posts: 11
Joined: Fri Mar 27, 2015 10:53 pm

Re: printerboard set up

Post by kryptonian » Tue Apr 21, 2015 5:01 am

hello..i know im bothering u..but im still struggling to get my sanguinololu 2560+ramps 1.4 printer board to initialize..i going online to see videos and its not helping..The firmware u sent me does not appear in the boards selection..i saved it on adruino hardware..i open adruino hardware and it does not appear...I feel like breaking this printer..the lcd does not display the graphics, :( its just comes on blank..
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: printerboard set up

Post by zhangxueyou » Tue Apr 21, 2015 9:25 am

kryptonian wrote:hello..i know im bothering u..but im still struggling to get my sanguinololu 2560+ramps 1.4 printer board to initialize..i going online to see videos and its not helping..The firmware u sent me does not appear in the boards selection..i saved it on adruino hardware..i open adruino hardware and it does not appear...I feel like breaking this printer..the lcd does not display the graphics, :( its just comes on blank..
No Sanguinololu 2560+ramps1.4. -_-!.....Could you please tell me the correct mainboard type? Sanguinololu or Mega2560+ramps1.4??
Top
Post Reply

Return to “Control Board”