RAMPS-FD

Lemon · Post by **Lemon** » Tue Jul 29, 2014 1:50 pm

Dear friend,
Could you please uninstall the driver first, and then follow the steps:
1. Remove FD, remain DUE only, and please don't connect DUE with Computer.
2. Upload the driver via this link:
http://www.driverscape.com/download/arduino-due
3. Plug DUE again, let it installed automatically.

After finish tested, please tell me the results.
Waiting your reply. Best regards.

ps2gator.ebat · Post by **ps2gator.ebat** » Tue Jul 29, 2014 3:06 pm

that link had a bunch of links that it tried to trick me into installing malware with huge "DOWLOAD NOW" buttons and fake "Download" buttons...I found the correct link eventually, but the page seems kind of strange.

Everything behaves the same with that driver as with the old

Lemon · Post by **Lemon** » Wed Jul 30, 2014 10:05 am

Dear friend,
Could you please download Driver Genius?
This is the link:
http://www.drivergenius.com/

Best regards.

ps2gator.ebat · Post by **ps2gator.ebat** » Wed Jul 30, 2014 12:06 pm

that site is not in english.

the USB works fine when the FD power is off, and stops working when the power is on. This hardly seems like a driver issue.

Lemon · Post by **Lemon** » Thu Jul 31, 2014 10:30 am

Dear friend,
You can pull out jumper caps on VIN, and then use USB supply power.
Best regards.

ps2gator.ebat · Post by **ps2gator.ebat** » Sun Aug 03, 2014 11:11 am

with the vin jumper out, it acts the same as in my original post.

still not working.

Lemon · Post by **Lemon** » Mon Aug 04, 2014 10:33 am

Dear friend,
Could you please use USB to connect DUE and computer?
Please note that don't connect to FD and other peripheral device module.
Waiting your reply.
Best regards.

ps2gator.ebat · Post by **ps2gator.ebat** » Mon Aug 04, 2014 10:41 am

Yes. I have it connected to the usb.

what would you like me to do with it?

Lemon · Post by **Lemon** » Tue Aug 05, 2014 3:00 pm

Dear friend,
Could you please tell me whether you can find com port or not when you connect DUE and Computer?
If not, maybe there has problem on 16u2. You can use usbtiny to upload bootloarder.
If you can find com port, the mcu probably has problem.
Waiting your reply. Best regards.

ps2gator.ebat · Post by **ps2gator.ebat** » Sat Aug 09, 2014 2:22 am

The Due communication works fine, unless the FD is connect with the power on AND the jumper as described.

Geeetech

RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD

Re: RAMPS-FD