Hi all
I am new to the world of 3d printing. I want to fabricate a 3d printer. I purchased GT 2560 3d controller box ( P13 A pro) and installed Repetier- Host V2.0.5 software,serial port drivers . Then connected the controller to pc with USB cable. Its showing as connected. Is this enough to run the 3d printer. Or do i need to install marlin too?( i am not familiar with marlin.)
Thanks
GT 2560
Re: GT 2560
Could you upload the video to Youtube and then attach the link to the post?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: GT 2560
Dear Willam
Thanx for your feed back.
https://www.youtube.com/watch?v=2Ti5YZobCsY
Please refer the above link.Do we have any user manual for this controller? i found one but it is not a complete one.
Thanx for your feed back.
https://www.youtube.com/watch?v=2Ti5YZobCsY
Please refer the above link.Do we have any user manual for this controller? i found one but it is not a complete one.
Re: GT 2560
You can refer to this pdf file
https://drive.google.com/open?id=1LlcOl ... 0fSphLt0Q-
Seems you haven't built the heated bed and nozzle heating cable and Endstop cable.
https://drive.google.com/open?id=1LlcOl ... 0fSphLt0Q-
Seems you haven't built the heated bed and nozzle heating cable and Endstop cable.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: GT 2560
Actually we are fabricating the whole 3d printer. we bought the P13A pro controller. My doubt is, whether i can use printrun or repietier-host software to run the printer? or Marlin is a must one?
I hope i can calibrate the axis via M92 command in printrun. Am i correct?
I hope i can calibrate the axis via M92 command in printrun. Am i correct?
Re: GT 2560
GT2560 basic on Marlin firmware.You can send M92 for calibration
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!