Print head not staying level to sides of bed
Print head not staying level to sides of bed
Got a Delta Rostock mini G2S Pro. When I centre my print head on the bed, and move the head in any x,y direction it lifts about 5mm. Can sombody please help me with this problem, because as long as that happens i cant print anything with this printer.
Re: Print head not staying level to sides of bed
Did you level your bed as the manual shows?
If you did,try to set the value in the picture to -5 have a try:
If you did,try to set the value in the picture to -5 have a try:
- QQ截图20160922103131.jpg (48.4 KiB) Viewed 4406 times
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Print head not staying level to sides of bed
Thank you. Tried it, but had the same problem. got hold of settings in the firmware and after a lot of hours i got the problem solved. Thanks for the reply 
Got a new problem since i tried to print in 2 colors. 1st color print perfect, but when 2nd color starts the heads lift to about 180 and print there and when 1st color prints again it lifts even more to end stops en then its chaos.
Got a new problem since i tried to print in 2 colors. 1st color print perfect, but when 2nd color starts the heads lift to about 180 and print there and when 1st color prints again it lifts even more to end stops en then its chaos.