MKS TMC2100 stepper motor driver

Fluxcore · Post by **Fluxcore** » Sat Apr 16, 2016 3:35 am

Is it possible to use these on the control boards supplied with Geeetech printers ?

Mark · Post by **Mark** » Sat Apr 16, 2016 1:44 pm

Are they compatible with A4988? If so you can use it on the board I think.

neoprogger · Post by **neoprogger** » Mon Sep 19, 2016 2:40 pm

They are compatible.
Do I need to adjust any voltage?
According to http://blog.gummibaer-tech.de/tmc2100-s ... olu-a4988/
it is not needed.

Thanks !

neoprogger · Post by **neoprogger** » Wed Sep 21, 2016 9:33 pm

Update: Just replaced 3 of my Drivers.
in spreadCycle Mode they produce a lot of noise when powered with 12 volts.

The StealthChop works perfectly. Just remove all 3 jumpers and dont connect pin conf1-3.

Voltage is adjusted to 0,6V, works just fine.

Nearly noiseless running now.

Post by **William** » Thu Sep 22, 2016 10:04 am

Thanks for sharing.

Geeetech

MKS TMC2100 stepper motor driver

MKS TMC2100 stepper motor driver

Re: MKS TMC2100 stepper motor driver

Re: MKS TMC2100 stepper motor driver

Re: MKS TMC2100 stepper motor driver

Re: MKS TMC2100 stepper motor driver