can i take a look at your control board, you need to use jumper cap if you use 8825.
you can check the building instructions, it was mentioned in wiring.
Not printing after control board change
Re: Not printing after control board change
hey admin
i have all the three jumpers under each driver!
anycase i can not discovery which one is the multiply, could you show on this pic which is the MS1 Ms2 MS3?
Turn ON/OFF Subdivision
MS1 MS2 MS3
OFF OFF OFF full step
ON OFF OFF 1/2 step
OFF ON OFF 1/4 step
ON ON OFF 1/ 8 step
OFF OFF ON 1/16 step
ON OFF ON 1/32 step
OFF ON ON 1/32 step
ON ON ON 1/32 step
http://www.geeetech.com/wiki/images/f/f ... wiring.jpg
th building instrutions i have is this ones:
http://www.geeetech.com/Documents/Build ... 20M201.pdf
i have all the three jumpers under each driver!
anycase i can not discovery which one is the multiply, could you show on this pic which is the MS1 Ms2 MS3?
Turn ON/OFF Subdivision
MS1 MS2 MS3
OFF OFF OFF full step
ON OFF OFF 1/2 step
OFF ON OFF 1/4 step
ON ON OFF 1/ 8 step
OFF OFF ON 1/16 step
ON OFF ON 1/32 step
OFF ON ON 1/32 step
ON ON ON 1/32 step
http://www.geeetech.com/wiki/images/f/f ... wiring.jpg
th building instrutions i have is this ones:
http://www.geeetech.com/Documents/Build ... 20M201.pdf