Printer Setup Problems

Post Reply
x306xcptnkirk
Posts: 42
Joined: Mon May 25, 2015 8:01 am

Re: Printer Setup Problems

Post by x306xcptnkirk » Thu May 28, 2015 11:17 am

It was only connected wrong because your company did not specify that it was different and noted that the screw had to be a certain way. The extruder makes a squeaking noise but does not move
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Printer Setup Problems

Post by zhangxueyou » Thu May 28, 2015 11:23 am

x306xcptnkirk wrote:It was only connected wrong because your company did not specify that it was different and noted that the screw had to be a certain way. The extruder makes a squeaking noise but does not move
We've specified in wiki: http://www.geeetech.com/wiki/index.php/ ... nd_Setting
I think the driver is dead.
Top
x306xcptnkirk
Posts: 42
Joined: Mon May 25, 2015 8:01 am

Re: Printer Setup Problems

Post by x306xcptnkirk » Thu May 28, 2015 11:27 am

So what are you going to send me to repair the printer? No where in the manual that was emailed to me or any info given did it state that. That was the first time I had seen it. It isn't even under the printer settings.
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Printer Setup Problems

Post by zhangxueyou » Thu May 28, 2015 11:31 am

Sorry, I can't help you. My job is to help customer solve technique issues. Please contact customer service.
Top
Post Reply

Return to “Control Board”