No energe at the out of Sanguino card

Post Reply
heistanbul
Posts: 7
Joined: Mon Apr 20, 2015 3:00 pm

Re: No energe at the out of Sanguino card

Post by heistanbul » Tue Apr 21, 2015 10:10 am

The hotbed thermistor is broken. When I change this part, is the bed heater to work? The problem only is this piece?
Image
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: No energe at the out of Sanguino card

Post by zhangxueyou » Tue Apr 21, 2015 10:33 am

It'd better be the same type of thermistor, or you have to make some change in firmware.
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: No energe at the out of Sanguino card

Post by zhangxueyou » Wed Apr 22, 2015 2:22 pm

Swap the connection of hot bed thermistor and extruder thermistor (connect hot bet thermistor to "E-THERM"，connect extruder thermistor to "B-THERM), turn off the printer and turn it on again, what are the first line and 4th line of the LCD screen displaying?
Top
Post Reply

Return to “Control Board”