It looks like there's no contact somewhere.
Did you try to change the place of stepstick modules?
To do a test.
Problem with y axis
Re: Problem with y axis
Hello.
It looks like there's no contact somewhere.
Did you try to change the place of stepstick modules?
To do a test.
It looks like there's no contact somewhere.
Did you try to change the place of stepstick modules?
To do a test.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.