Working fine in the past, there were no changes, now after starting the machine I have problems with the Y-axis. The y-axis is not going home, I have a Geeetech i3 with bord GT2560.
Manual movement by software and bed in the middle it is possible to move to both sides, and by home the bed is still in de middle.
By pushing the home on the printer, the y-axis moves a few steps in the wrong direction.
Y axis don't go home
Re: Y axis don't go home
Hi,Are you downloading in firmware GT2560? http://www.geeetech.com/forum/viewtopic ... 13&t=17181
In this case, the X-Axis go home?
In this case, the X-Axis go home?
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!