Page 1 of 1
Y movement changes during print
Posted: Mon Feb 05, 2018 11:21 pm
by Graham
My prints start good but after a short time the Y motor clicks and misses steps meaning that the y direction is about halved. The stepper functions well at the start but after about a minute jumps into this click and missing step routine. Can any one help?
Re: Y movement changes during print
Posted: Tue Feb 06, 2018 9:41 am
by William
I think you can swap the Y axis and X axis motor driver board A4988
Then you can test it.You will find the issue is A4988 or not
Re: Y movement changes during print
Posted: Tue Feb 06, 2018 12:04 pm
by _kaktus_
You can increase the controller current.