Y axis moves 4 times too far then X axis!!??
Posted: Thu Nov 02, 2017 1:43 am
Hey!
I am a beginner of this.
I have uploaded Marlin 1.1.6 to Geeetech 2560 rev. A Geeetech Prusa i3. In Configuration h. I have 7 as motherboard.
Has set DEFAULT_AXIS_STEPS_PER_UNIT {78.74,78.74,2399,102.5} Everything works except that the Y axis moves 4 times too far. The X-axis is perfect. As I see it, X have the same physical conditions as Y.
What do I miss?
Regard
Ola A.
Linköping
Sweden
I am a beginner of this.
I have uploaded Marlin 1.1.6 to Geeetech 2560 rev. A Geeetech Prusa i3. In Configuration h. I have 7 as motherboard.
Has set DEFAULT_AXIS_STEPS_PER_UNIT {78.74,78.74,2399,102.5} Everything works except that the Y axis moves 4 times too far. The X-axis is perfect. As I see it, X have the same physical conditions as Y.
What do I miss?
Regard
Ola A.
Linköping
Sweden