Geeetech

Hello,

I have a Prusa i3 M201 with the GTM32 Pro B board and I was wondering what the slowest travel speed that it can achieve.

Ideally, I would like for it to move less than 1 mm/s, perhaps even 1/10 mm/s if it is possible. Please let me know if you have any ideas that can assist me in making the travel speed very slow.

Thank you!

We used to calibrate the lowest speed to 30 mm/s , you are just able to have a try moving less than 1 mm/s that do less harm to your printer.

William wrote: ↑

Mon Aug 07, 2017 11:49 am

We used to calibrate the lowest speed to 30 mm/s , you are just able to have a try moving less than 1 mm/s that do less harm to your printer.

How will I be able to try this? I am able to get it to about 1 mm/s but I would like to get it to be even slower. Will this harm my printer?

There is no harm to your printer even you get it to 0.1mm/s ,to be honest ,I have not tried the such lower printing speed.