Geeetech

Hello

I have just assembled my Geeetech Acrylic Prusa I3 pro B but I cant get my steppers to move also I cant get the extruder to warm up.

I can read the temp for the bed and the extruder.

I have read that it could be a firmware issue can you send me the newest version?

this is the board



Best regards
BluDK

Hi,
Can the board be connected to your computer and Repetier Host?
1.About the motor not moving,check this:
http://www.geeetech.com/forum/viewtopic ... 17&t=17038
2.Heating issue:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
3.Check the control board:
http://www.geeetech.com/forum/viewtopic ... 18&t=18061
If all of this can't fix your problem,try uploading the firmware,I've put it in the attachment.
Let me know plz if you find something new.