Geeetech

Good evening guys,
I'm Dennis from Germany and i got a disgusting problem with my Geeetech Prusa i3.
I will upload a video to describe my problem more detailed.
My extruder steppermotor isnt moving really well.
As you can see in my video the filament isnt moving into the hot end. I think the reason for this is the stepper motor.
My printing results are very bad. Especially my Infill got no clear printing line.

Here the video : https://www.youtube.com/watch?v=f0VyDt-S-r8

Thanks for help.

mossos wrote:Good evening guys,
I'm Dennis from Germany and i got a disgusting problem with my Geeetech Prusa i3.
I will upload a video to describe my problem more detailed.
My extruder steppermotor isnt moving really well.
As you can see in my video the filament isnt moving into the hot end. I think the reason for this is the stepper motor.
My printing results are very bad. Especially my Infill got no clear printing line.

Here the video : https://www.youtube.com/watch?v=f0VyDt-S-r8

Thanks for help.

Hi,Dennis
Having watched your video carefully,i guess your extruder has a clogging or the distance between the nozzle and the heat bed is too close.You may want to read this:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097