Page 1 of 1
PRUSA I3 PRO C ALL AXIS INVERTED
Posted: Fri May 20, 2016 5:57 am
by Ulepo
Hi I have just built my new printer prusa i3 pro c and everything has been easy up to now.All the axis are going in the wrong direction.I have done it as it says in the manual.I have read somewhere to turn the stepper motor plugs 180ยบ,but the plugs only go one way and it is as they came in the box. Maybe something wrong with the firmware?
Re: PRUSA I3 PRO C ALL AXIS INVERTED
Posted: Sat May 21, 2016 11:54 pm
by Ulepo
Well, Ihave solved it. My ploblem was the Arduino 1.6.9 and my unknowlegde.
The Arduino 1.6.9 didn't let me write in the gt2560. So I uninstalled it and changed to Arduino 1.0.1.
Then everything was ok. I could invert x,y,z axis ,so the machine goes in the right direction.
I only have a problem with y max endstop, but this is not from this post.
Maybe this can help to someone.